Due to recent issues and the latest announcement from BETAFPV, do not use 4s lipos with the 85x. 2s -3s max.
This BLHeli_32 16A ESC is customized for the whoop drones Beta85X. This is the first micro drone that comes with a BLHeli_32 ESC.
BLHeli_32 is the 3rd generation ESC firmware after BLHeli and BLHeli_S, which is written for ESC‘s that utilize 32-bit MCU. With the increase in processing power, faster input signals with lower latency and higher update rate would be possible in BLHeli_32, such as Dshot1200!
Know more about BLHeli_32 ESC from Oscarliang's blog.
SPECIFICATIONS OF ESC
- Support BLHELI_32
- Support PPM, Oneshot125, Oneshot42, Multishot, Dshot150, Dshot300, Dshot600, Dshot1200
- Input voltage: 2-4S lipo
- Cotinue current: 16A
- Peak current: 35A
- Firmware target: BETAFPV-16A-32bit
- Motor Connectors: 1.25mm header pins connector
HOW TO ASSEMBLE FC & ESC
Note: Please assemble the FC and the ESC as the picture shown below, otherwise the fc will be BURNT to damage.
RECOMMENDED PARTS LIST
- Frame: Beta85X frame
- Motors: 1105 motors / 1103 motors with 1.5mm header pins connector
- Battery: 450mAh 3S battery / 450mAh 4S battery
RECOMMENDED RECEIVER CONNECTION
All the ports are available on this board. So that you could connect any receiver you want on the board. For example.
- Frsky XM/XM+ Receiver
- TBS receiver
- DSMX receiver
For the details about how to connect the receiver and configure in Betaflight, please check the F4 2S Brushless FC & ESC Manual.